Call Us
Call Us
Seam360 A 360 Degree View Of The Double Seam

Seam360 A 360 Degree View Of The Double Seam

Product Details:


Product Description

Seam360 A 360 Degree View Of The Double Seam


The SEAM360 is the ultimate machine vision double seam can inspection gauge. The system is used for both three piece and two piece beverage and food cans.

Conventional seam scan technologysample seams at 2-3 points around the can. However, what about the points in between the sample points?

If you measure at a few points around the seam, using a micrometer or seam thickness gauge and destructive tests with a seam scope youre missing most of your information!

Problems can arise as close as a few millimeters from your measurement point and you will not detect them. This means that if a problem is missed, it can be a few more shifts before the problem is detected resulting in many bad cans being closed or even shipped!

Instead of trying to measure every can (100%) but at a few measurement points, the SEAM360 measures every cans total external surface area. This exposes many issues that were so far invisible to the operator!

X-ray systems measure at only a few points around the can, and pressure systems on the seamer can miss even obvious issues because of their technology (e.g., false seams!).

Using non-destructive optical technology, Quality By Visions new SEAM360 is capable of detecting all of these double seam issues in a fraction of the time it takes to do a seam test and with no operator influence on the results! SEAM360 is the first system capable of checking every point on the seam, so theres no chance of missing anything.

This means problems with the seamer, loose or tight roll and chuck setups, double seam issues (including rare ones) are easily detectable for any seamer head.

The intuitive software clearly points out what the problem is and where it occurred.

Many tooling and seamer related issues can be fixed quickly, using the Clearance Gauge.

    • Laboratory  SEAM360 tests one can at a time in a lab environment.
    • Continuous  SEAM360 grabs a number of cans off the line every X minutes, tests them, and alerts when there is a problem.
    • Manual  Bring cans to the machine, line them up and start the test SEAM360 will produce a report and statistics graphs at the end of the measurement process.
    • Automatic  SEAM360 grabs one can from each head every X minutes and tests all of them. If one of the cans is marked by a dimple as being from Head

#1, SEAM360 will detect it and match that can with the correct head on the report!

      • Tests for seaming problems all around the seam, not just at 2-3 points
      • Detects and locates hard to find errors that can be easily missed in a seam test, such as compound buildups, variations around the seam, skids, wrinkle, and more!
      • An affordable alternative to X-ray based systems
      • Much faster and more reliable than conventional external seam gauges
      • Less expensive than other fully-automatic seam testers and NON DESTRUCTIVE!
      • Droops & Vees
      • False seams
      • Broken chucks
      • Tooling & Bushing problems
      • Seam gap issues
      • Overlap problems
      • Overhang
      • Seam bumps
      • Knocked-down flange
      • Dead-heads & chuck skids
        and best of all Its non-destructive!


Resolution 0.0002 (two ten-thousandths) or better for seam thickness and length
Interface USB2
Optical units Laboratory (manual)
In-line (automatic)
Scan time (one can) about 8 seconds
Measurement cycle time (6 cans) about 2 minutes

Enter Buying Requirement Details
Email Id
Mobile number